Stress Test with Load Step Curve allows you to check the response time of your website by gradually changing the number of concurrent users during a predefined time duration. 

How it works

Based on the starting number of concurrent visitors and their arrival/departure rates, LoadView creates the load curve. The Load Curve chart on the page updates as you make changes and gives you a visual representation of the load to the device and how it will change over the course of the test.

Configuring a Load Step Curve

To verify if the device is configured properly and the web site can handle the minimum load, you can use the default scenario steps to run a verification test. Based on the verification test results you may need to adjust your device settings before running the test with a higher load.  

Not all types of device errors can be detected upon validation. For example, we want to test logging in with a number of concurrent users. However, let’s assume the site allows logging in only for one concurrent user at a moment. In this case, the device will pass validation successfully since a single-user test will be executed. At the same time, the site will reject all logging in attempts except the first one and the errors will occur.

To set up your custom scenario, change the presets in the scenario fields according to your goal (e.g., the number of simultaneous users you are expecting to have on your web site).

To add a new custom step, click the Action button on the bottom of the scenario section and select a necessary step type. The following steps are available:

  • Start with – the starting user load. It could take some time to simulate the starting number of users. 
  • Raise by – load ramp-up rate. The number of users is increased by this value each minute during the specified time. 
  • Hold for  – load duration. The load reached on the previous step remains constant within the specified time.
  • Lower by – load ramp-down rate. The number of users is reduced by this value each minute during the specified time. 

To delete a step, point to the end of the related line and click the move to trash button. 

Deleting a step

Once the Load Step Curve is configured, proceed with VUD and Zones configuration as described in Getting started with Stress Test Setup.

When the test finished, you can view test results on the Stress Test Report page. Also, it is recommended to check the Session Report for errors detected.